Filmwasters
Which Board? => Main Forum => : Adam Doe April 17, 2016, 09:56:02 PM
-
They make neat frames for your pack film shots. You just need to pop the backs off, drill or use a hole punch to create a hole in the back, use some tape to adhere the photos in to keep them from shifting and then snap the back on.
-
My dad always did this with empty SX70 packs! I, of course, continue the tradition :)
-
That's pretty neat. And no waste either.
Best of all is it can also be done using an Instax back with just a few mods.
-
Put a couple of rollers and a motor with a timer in it with your 10 shots all taped together and you have an analog version of those fancy schmancy digital frames! 8)
-
;D
-
Put a couple of rollers and a motor with a timer in it with your 10 shots all taped together and you have an analog version of those fancy schmancy digital frames! 8)
Ha! I think I'd have to leave that up to someone with more DIY ingenuity, like Francois.
-
I was saving some so that I could possibly still use the cameras after my stock of pack film is gone. I could cut down a 4x5 negative, insert it like you did and then have a single shot.
-
I have put single 4x5 sheets into my Land 900. It's kind of cool, but that's a bit of a boat anchor to lug around for one shot. I suppose I could reload in a bag, but if I'm going to carry all that stuff, I'll just take the Speed Graphic out.
-
I have put single 4x5 sheets into my Land 900. It's kind of cool, but that's a bit of a boat anchor to lug around for one shot. I suppose I could reload in a bag, but if I'm going to carry all that stuff, I'll just take the Speed Graphic out.
I agree, probably something I would do once or twice.
-
you can put wet/dry plates into the pack film holders, or use the holders themselves as plates too if you wanted to once your pack film has gone...