Filmwasters
Which Board? => Main Forum => : astrobeck January 28, 2022, 09:12:28 PM
-
Hi all,
I've been going to ask this question forever and keep forgetting until a day like today happens.
I develop color and the blix sneaks out of the developing tank.
I just mixed up a nice new Cinestill kit and developed the first roll no problem...except the red/dracula blood red blix leaks out of it no matter how much I try to seal it.
what's the trick?
I've doing 35mm and hardly ever 120 color.
I'm going to run out of blix before my third roll at this rate.
Thanks!
-
Is it because the pressure builds-up in the tank and then the lid starts leaking?
In that case just venting the tank from time to time should fix it.
-
hmmmm.
It's possible I reckon. I'm using a Patterson tank that doesn't leak when I use it for B/W....ever.
Maybe I should just use the metal wire reel one?
-
I find the Paterson tanks are the most leak proof if you burp the lid. I prefer to use stainless steel tanks with stainless steel lids but they seem to leak the most. The plastic lids seal better on stainless steel tanks but I have had a few of them that eventually cracked. I wrap the stainless steel lid shut with electrical tape but the liquid still seems to find its way out even with three full wraps with the tape.
-
Yup, burp the lid often, especially with freshly mixed chems. Older blix isn't as volatile.
-
Or just leave the lid off and use the twiddle stick... Something to do under the stove hood exhaust fan...😐
-
I always found my tank leaks all over the place if i invert it during colour processing, but is absolutely fine with black and white chemistry, so to save a horrible mess I just use the stick to rotate the spiral back and forth instead of inversion when I'm doing colour.
-
I have the impression that it's the high temperature at which you develop colour. I have the same problem with my Paterson tanks. I suspect that the lid simply expands more than the rest of the tank. With the Tetenal C-41 kit I was able to develop at 25 °C and there's as little leakage as when I developed B&W.
-
I'm with everyone one here concerning the mixture temp. I use the Patterson tanks too and find
that after my first inversion I simply crack the lid and lightly compress the top at the same time and
reseal the edge of the lid . Works every-time . Peter
-
I wonder if the Jobo tanks wouldn't be less leaky?
They are made to be used on their sides...